NUX JTC Pro Drum & Loop Effects Pedal

The NUX JTC Pro is an advanced drum & loop effects pedal with simplified controls. It’s a dual-switch stompbox pedal with 6 hours of recording capability and 256 loop track memories. The audio recording quality is 24-bit and 44.1kHz sample rate. Dual-Switch Action Loop and the drum controls are separated, left footswitch (LOOP) controls recording and overdubs, and start/stop plays the recorded loop tracks. It’s also TAP Tempo control, you can set the drum speed by tapping the left footswitch before you record a track. Looper Action There are two loop recording actions on JTC Pro; Record and Play (RP), and Record and Overdub (RD). In Record and Overdub action; JTC Pro will record it over and over while playing the previous tracks High Quality Drum Sound—Smart Drum Fills Right footswitch (RHYTHM) controls the drum and it adds a drum fill during the performance. Drum fills length is one measure (depends on 4/4 or 3/4 rhythms). When you hit the RHYTHM button, drum fill will start immediately and it will play until the end of the current bar. For example if you push the switch at 3rd beat -> drums fill length will be 2 beats only. There are 40 drum patterns and fills including Pop, Rock, Blues, Metal and more other styles with 3/4 and 4/4 beats. Start/Stop Modes It has very useful and stop modes for making your jam sounds like an arranged song during the performance. There are two Start Modes and three Stop Modes: Start Modes Press and hold the Stop Modes button, and select a start mode; (Ar) Auto-Recording, (Nr) Normal Recording Normal Recording - Classic hit and play looper action. JTC Pro will start recording when you push the loop switch. Auto-Recording - In this mode, when you push the loop switch, the JTC Pro will be standing by for recording. And it will start recording immediately when you hit the guitar strings. Stop Modes After you record a track, you can simply push the Stop Modes button, and choose one of the modes to finish your performance the way you like. Normal Stop - Double hit to Loop switch and the looping track will stop immediately. Fine Stop - Double hit: The track will play until the end then it will stop, don't forget to hit finishing chord after it stop. Fade Out - The track volume will be decreased to 0 slowly in 10 seconds then it will stop. One-Shot Mode And, One Shot mode is very useful for playing any loaded backing track without looping. You can load any song to play along, the supported file type is 24-bit/44.1kHz Stereo Wave (.wav) You can download NUX Audio File Converter to change the audio file format and make it compatible for JTC Pro. Advanced Output Options and Frequency Optimization (FR ON/OFF) JTC Pro has two outputs and there are several output modes; a stereo connection to two amplifiers, or you can activate the built-in speaker cabinet simulation for Right Output to send your guitar signal directly to a PA system (or any PA monitor). JTC Pro’s drum sound is high-quality real sound, when you connect to any guitar amplifier or PA system you will hear a full range and dynamic drums, still, if you are using a small practice amplifier there is an optional drum frequency optimization. It makes the drum sounds more clear and helps you to get a real looper experience with the smaller amplifiers. External Footswitch Input You can connect NUX NMP-2 control footswitch (sold separately) or any equal pedal to use as a controller. You can switch Up and Down between the memory slots. When you push the UP or DOWN button, the current track will be played until the end, you can switch right next to preset or jump between several presets at once.